VCH37 Series Vacuum Cup Holder

The distinctive feature of these cup holders is their articulated joint in hardened steel, which allows the flat cups installed on these cup holders to adapt themselves to the loads to be lifted even if not completely parallel with the cup plane, as well as to compensate possible verticality errors that can arise between the cup holder and the automation fixing support. The cup holder fixing bush is located between two springs: the lower one cushions the impact of the cup with the load to be lifted during the approach phase, while the upper one cushions the impact of the bush with the cup holder end and gradually loads the cup during the lifting phase. These cup holders are especially recommended when the load to be lifted is very heavy, rough or not perfectly flat.
The actual springing stroke is:
For height C= 55 mm 37 mm
For height C= 110 mm 84 mm